Cleveland SSE-25-L Installation, Operation And Repair Manual page 21

ALL KETTLES AND SKILLETS
HINGE ADJUSTMENT INSTRUCTIONS
1. Insert 3/8" Allen wrench.
2. Turn clockwise to relieve tension on spring.
3. While tension is released remove one of the two slotted screws.
4. To prevent Allen wrench from springing back abruptly while the second slotted screw is
removed, insert a pin (approximately 1/8") in the hole where the first slotted screw was
removed from.
5. Remove second slotted screw.
6. While holding Allen wrench remove pin.
7. Turn Allen wrench clockwise to tighten or counter-clockwise to loosen tension to produce
desired effect.
8. Re-insert pin in one of the two holes.
9. Tighten one slotted screw in the other hole (it may be necessary to turn Allen wrench
slightly to align holes.)
10. Remove pin and repeat step number 9 for other slotted screw.
19