Epson TM-L90 Technical Reference Manual page 41

4. Push the roll paper spacer until it clicks.
Note:
Check that the roll paper spacer slides smoothly from side to side.
5. Slide the roll paper spacer side-to-side and set it to the appropriate position. Use the
measurement lines if necessary.
Note:
Roll paper is placed on the tab-free side of the roll paper spacer.
When positioning the roll paper spacer, provide 0.5 mm of room for the maximum roll paper width.
screw
6. Secure the roll paper spacer with the supplied screw. (See above.)
7. Make the setting for the paper width with the memory switch.
For information about the memory switch, see "Memory Switch Settings" on page 44.
TM-L90/TM-L90 Peeler Model Technical Reference Guide
measurement
Setup 41