Setting Items Of Tm-L90 Other Than 4** Models - Epson TM-L90 Technical Reference Manual

Setting items of TM-L90 other than 4** models

See "Memory Switch Settings" on page 44 for the procedures for the memory switch setting
mode.
1st page
1: Auto Cutter
2: Paper, Print Density
3: Basic Serial Interface Settings
4: Advanced Interface Settings
6: Interface Reset Signal
7: Paper Width
Setting Items
2nd page
1: Monochrome
2: Two color
TM-L90/TM-L90 Peeler Model Technical Reference Guide
* The initial setting is underlined.
Install, Uninstalled
[Print density set up]
70%, 75%, 80%, 85%, 90%, 95%, 100%, 105%, 110%, 115%,
120%, 125%, 130%, 135%, 140%
[Print density set up]
70%, 75%, 80%, 85%, 90%, 95%, 100%, 105%, 110%, 115%,
120%, 125%, 130%, 135%, 140%
[Baud rate set up]
2400 bps, 4800 bps, 9600 bps, 19200 bps, 38400 bps, 57600
bps, 115200 bps
[Data bits / Handshaking / Parity set up]
8 bits / DTR/DSR / none
8 bits / DTR/DSR / even
8 bits / DTR/DSR / odd
8 bits / XON/XOFF / none
8 bits / XON/XOFF / even
8 bits / XON/XOFF / odd
7 bits / DTR/DSR / none
7 bits / DTR/DSR / even
7 bits / DTR/DSR / odd
7 bits / XON/XOFF / none
7 bits / XON/XOFF / even
7 bits / XON/XOFF / odd
[Buffer Capacity / Receive Error / Handshaking Operation
(Busy Condition)]
4 Kbytes / prints '?' / Off-line or Receive buffer full
4 Kbytes / prints '?' / Receive buffer full
4 Kbytes / ignore / Off-line or Receive buffer full
4 Kbytes / ignore / Receive buffer full
45 bytes / prints '?' / Off-line or Receive buffer full
45 bytes / prints '?' / Receive buffer full
45 bytes / ignore / Off-line or Receive buffer full
45 bytes / ignore / Receive buffer full
[Serial #25 / Serial #6]
Disable / Disable
Disable / Enable
Enable / Disable
Enable / Enable
38 mm, 58 mm, 60 mm, 70 mm, 80 mm
Options
Appendix 125