Setting Items Of Tm-L90 Peeler Other Than 39* Models - Epson TM-L90 Technical Reference Manual

11: Label
Settings
12: Paper Feed
Settings
13: Other
Settings

Setting items of TM-L90 Peeler other than 39* models

See "Memory Switch Settings" on page 44 for the procedures for the memory switch setting
mode.
1st page
2: Paper, Print Density
128 Appendix
1: Automatic measurement of
maximum length
2: Moving to the print start position
5: Select manual feed operation in
Continuous issue mode
2: Interface 1: Receive Buffer
Settings Capacity
2: BUSY Condition
3: Auto Line Feed
4: State to cancel
buffer BUSY
5: Error Signal
3: Near-End LED
4: Transmit the power ON
information
5: Recovery layout error
Setting Items
2nd page
1: Monochrome
2: Two color
160 mm, 300 mm
Disabled, Enabled
Paper feed to the print starting position, Paper feed to the
peel position
4 KB, 45 bytes
Receive Buffer Full or Offline, Receive Buffer Full
Always disabled, Always enabled
Not BUSY = 256 bytes, Not BUSY = 138 bytes
Enabled, Disabled
Disabled, Enabled
Does not transmit, Transmit
DLE ENQ
DLE ENQ or Main cover open/close
DLE ENQ or press down PAPER FEED button
DLE ENQ or Main cover open/close or press down PAPER
FEED button
* The initial setting is underlined.
[Print density set up]
70%, 75%, 80%, 85%, 90%, 95%, 100%, 105%, 110%, 115%,
120%, 125%, 130%, 135%, 140%
[Print density set up]
70%, 75%, 80%, 85%, 90%, 95%, 100%, 105%, 110%, 115%,
120%, 125%, 130%, 135%, 140%
Options