Epson TM-L90 Technical Reference Manual page 140

Die Cut Label
Allow 2.8 mm or more from the left and right edges, and 1.5 mm or more from the top and
bottom edges for the printable area.
2.8 or more
Note:
If the margins are not set, the printing may be off the label due to paper misalignment or the part
tolerance.
Liner width (mm)
Label (face stock) width
(mm)
Printable area (mm)
Left margin (mm)
Right margin (mm)
Positioning dot number
Total number of dots
The label must be positioned in the center of the liner. Numeric values used above table are center values in
designing. Paper width is only for nominal dimension. The values in parenthesis are the maximum value for the paper
tolerance.
Continuous Label Roll Paper
Allow the left and right margins of 2.8 mm or more outside the printable area.
140 Appendix
Liner width
Label (face stock)
Printable Area (for die cut label)
(80) (70)
76 66
70 60
2.9 2.9
3.1 3.1
17 - 576 17 - 496
560 480
2.8 or more
(60) (50)
56 46
50 40
2.9 2.9
3.1 3.1
17 - 416 17 - 336
400 320
1.5 or more
Printable area
1.5 or more
[Units: mm]
(45) (38)
41 34
35 28
2.9 2.9
3.1 3.1
17 - 296 17 - 240
280 224