Stihl FS 80 Instruction Manual page 24

4
3
5
6
7
: Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
: Fit the clamp (6) and place the
barrier bar (2) in position.
: Note correct position!
: Line up the holes.
: Insert screws (7) in holes and screw
them into the barrier bar as far as
stop.
: Go to "Securing the loop handle".
FS 80, FS 80 R, FS 85, FS 85 R
All manuals and user guides at all-guides.com
2
Loop handle without barrier bar
: Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
: Fit the clamp (6) and line up the
holes.
: Fit washers (7) on screws (8) and
insert screws in holes. Screw on the
square nuts (1) as far as stop.
: Go to "Securing the loop handle".
8
8
7
7
4
3
5
6
1
1
A
9
10
Securing the loop handle
: Secure the loop handle (4) approx.
20 cm (A) forward of the control
handle (9).
: Line up the loop handle.
: Tighten down the screws firmly –
lock the nuts if necessaey.
10 Sleeve*
* see "Guide to Using this Manual"
English
4
23