Filling In Oil - Siemens BA 2030 SERIES Operating Instructions Manual

8.2.6.4

Filling in oil

NOTICE
Mixing of different oils impairs the lubricity
When adding oil, use the same oil type and viscosity. If changing mutually incompatible
oils, see Flushing the gearbox (Page 73).
Observe the symbols in the diagrams of the Mounting positions (Page 95):
Venting
Procedure
1. Unscrew the vent plug.
2. Fill the gearbox with fresh oil. Use a filler filter with mesh of max. 25 μm.
3. Check the oil level.
4. Top up the oil level if necessary and check it again.
5. Check the state of the sealing ring on the sealing element. If the sealing ring is damaged,
replace the sealing element with a new one.
6. After filling with oil, seal the gearbox immediately using the sealing element.
You have now filled up the gearbox with oil.
BA 2030
Operating Instructions, 11/2017, A5E37880173A/RS-AE
Service and maintenance
8.2 Checking and changing lubricants
75