Hollow Shaft With Shrink Disk; Mounting The Hollow Shaft With Shrink Disk - Siemens BA 2030 SERIES Operating Instructions Manual

Installation
4.9 Installing and removing the shaft-mounted gearbox
4.9.3

Hollow shaft with shrink disk

4.9.3.1

Mounting the hollow shaft with shrink disk

a
b
*
①
②
③
Figure 4-6
Procedure
1. Using benzine or a solvent, remove the anti-corrosion protection from the shaft ends and
flanges.
2. Check the seats or edges of the hollow and machine shafts for damage. Contact
Technical Support if you notice any damage.
3. Mount the gearbox with the shrink disk shaft onto the machine shaft. Carefully ensure the
correct position and that the shrink disk seat completely covers the machine shaft.
You have mounted the hollow shaft with shrink disk.
38
Greased
Absolutely grease-free
Not included in scope of supply
Machine shaft
Hollow shaft
Bushing
Mounting the hollow shaft with shrink disk
Operating Instructions, 11/2017, A5E37880173A/RS-AE
BA 2030