Table of Contents
Advertisement
Procedure
1. Attach the torque arm
(Page 48).
2. Remove the corrosion protection coating using white spirit or a solvent on:
– The shaft ends of the machine shaft
– The clamping ring
– The bronze bushing
3. Check the seats or edges of the hollow shaft
Please contact Technical Support if you notice any damage.
4. Place the clamping ring
5. Position the bronze bushing
Observe the tightening torque of the tightening bolt
6. Oil lightly the locating holes in the hollow shaft
bushing
7. Push the gearbox with the installed torque arm
clamping ring
8. Tighten the torque arm
clearance for the subsequent mounting.
9. Ensure that the thrust collar
If the thrust collar
position by tightening the tightening bolts
10.Place the tapered bushing
11.Use the torque wrench to turn each of the tightening bolts
repeating this procedure several times. Observe the tightening torque of the tightening
bolt
12.Tighten the bolts
gearboxes (Page 48).
13.Attach the rubber cover or protection cover
Removing and installing the protection cover (Page 33).
You have installed the SIMOLOC assembly system.
BA 2030
Operating Instructions, 11/2017, A5E37880173A/RS-AE
⑦
to the gearbox, see Torque arms with shaft-mounted gearboxes
③
②
.
③
②
. Remove any excessive oil using a clean cloth.
③
.
⑦
with the bolts
⑤
is not placed at the correct position, bring the ring
⑨
⑩
.
⑧
of the torque-arm fastening, see Torque arms with shaft-mounted
4.9 Installing and removing the shaft-mounted gearbox
①
⑥
and the machine shaft
on the bronze bushing
②
with the clamping ring
⑥
for the tapered bushing
⑦
⑧
only gently because the gearbox must have
⑨
is placed at the correct position.
⑩
with turned tapered bushing
on the machine shaft
⑪
included in the scope of delivery, see
①
②
.
③
on the machine shaft
④
and the tolerance dimension to10.
①
on the machine shaft
⑤
①
.
⑩
equally (not crosswise),
Installation
for damage.
①
.
⑨
and bronze
against the
into the correct
⑨
.
45
Advertisement
Table of Contents
