Ce Certification And Compliance; Declaration; Maintenance - Mercedes-Benz Wallbox Home Operating Manual

Device safety standards
Standard
IEC 61851-1: 2017 Ed. 3.0
IEC/TS 61439-7:2014
IEC 61000-6-2:2016
IEC 61000-6-3:2006+AMD1:2010
IEC 61000-6-7:2014
IEC 61851-21-2: 2018 Ed. 1.0
Classes of protection & degrees of protection
Class of protection /
degree of protection
IP 55
CE certification and compliance declaration
The Mercedes-Benz Wallbox Home carries the CE mark. The associated declaration of compliance is available
for download in electronic format at
www.yourwallbox.de/downloads/documents/Declaration_of_Conformity_Home_Advanced.pdf.

Maintenance

After installation, your Mercedes-Benz Wallbox Home is mostly maintenance-free. However, because the Wallbox processes
high electrical voltages internally, it is recommended to conduct a visual inspection of the housing and check the externally
accessible components and accessories at certain intervals (e.g. biannually).
DANGER!
Never remove the internal electronic components cover of the Mercedes-Benz Wallbox Home: Cleaning or maintenance of
components behind this cover is not necessary, and must under no circumstances be performed by the user.
Conduct a visual inspection of the housing surfaces as well as the charging cable holder and check for damage.
•
Conduct a visual inspection of the charging cable and ensure that cable and charging plug do not show any visible damage
•
or deformation.
Should you find any obvious damage during the above-mentioned checks, please contact your local Mercedes-Benz technical
support. Have all damage repaired before continuing to operate the Wallbox. Until then, take the Wallbox out of operation as
described in section "Taking the product out of and back into operation" on page 9.
14
Explanation
Conductive charging systems for electric vehicles – Part 1: General requirements
Part 7: Switching device combinations for specific applications such as marinas, campgrounds, market
squares, charging stations for electric vehicles
Electromagnetic compatibility (EMC) - Part 6-2: Generic standards - immunity standard for industrial environ-
ments
Electromagnetic compatibility (EMC) - Part 6-3: Generic standards - Emission standard for residential, commer-
cial and light-industrial environments
Electromagnetic compatibility (EMC) - Part 6-7: Generic standards - Immunity requirements for equipment in-
tended to perform functions in a safety-related system (functional safety) in industrial locations
Conductive charging systems for electric vehicles – Part 21-2: EMC requirements for off board electric vehicle
charging systems
Explanation
The device complies with IEC protection class 1.
Degree of protection: complete protection against touch, protection against dust in harmful quantities and
against light water jets from any angle (DIN EN 60529: 2014-09)