Mercedes-Benz Wallbox Home Operating Manual page 11

4. Remove the charging plug from its storage holder and insert it completely
into the vehicle's charging socket: Communication with the vehicle is be-
ing checked and the Wallbox is awaiting authorization by the operator. In
this state, the LED will glow yellow.
5. Should the key switch on the right hand side of the housing be in the
horizontal position, you must turn it to the vertical position in order to
authorize the charging procedure.
As long as the key switch remains in the vertical position, you can
conduct further charging procedures at any time and without separate
authorization.
PLEASE NOTE!
Unblocking is only required to start the charging procedure: The key switch may be returned to the horizontal position im-
mediately afterwards, and this will not interrupt the current charging procedure. However, after severing the connection with
the vehicle, the next charging procedure is then again blocked by the Wallbox.
6. After authorization of the charging procedure via the key switch, the
Wallbox will wait for the charging procedure to be initiated by the vehicle.
In this state, the LED will glow green.
7. When the vehicle requests the charging procedure to be initiated and it
is started by the Wallbox, the LED will pulsate green during the charging
procedure.
If required, the charging procedure can be interrupted manually at the
vehicle (see operating manual of the vehicle to be charged).
8. When the charging procedure is paused or completed, the LED will con-
tinuously glow green again.
9. After the charging procedure is completed, disconnect the charging plug
from the vehicle socket and secure it in the charging plug storage holder
on the right hand side of the Wallbox.
The LED will now pulsate blue again, indicating that the Wallbox is ready
for the next charging procedure.
PLEASE NOTE!
Unless there is a malfunction, the charging procedure is only ever terminated by the vehicle or the user. When the LED
glows green, it indicates – on the basis of communication with the vehicle – that the charging procedure has been either
paused or completed: Distinguishing these two operating states is only possible by checking the displays inside the ve-
hicle. Should the vehicle, even after a sufficiently long charging procedure, not be fully charged, please contact your local
Mercedes-Benz technical support.
Key switch in horizontal position:
The next charging procedure is blocked.
Key switch in vertical position:
Charging procedure unblocked.
Mercedes-Benz Wallbox Home
| Charging procedure 7