Figure 53: Meter Setup And Security Screen; Table 12: Xrc G4 Displayed Items - ABB XSeriesG4 User Manual

Program display
G4
The XRC comes from the factory with a set of default displays as shown below in Table 12. By default, each display item
remains on the display for 5 seconds. This default can be changed to zero (item not displayed) or any value from 1 to 255
seconds. Engineering units can also be changed, as well as the data format for display purposes.
If the station is configured for measurement tubes or other applications, additional items will be scrolled.
Bi-Level security system
Data and configuration security in the XRC is spread across two elements: the hardware (XRC
and WinCCU32).
The meters (XFC, XRC, or µFlo) have a security switch (S1) on the electronic boards. Password security is bi-level: read only
(security code level 1), or read/write (security code level 2). The security switch (S1) only controls security through the local
PCCU connection. If the security switch is on, PCCU32 will be required to have the proper level of access. If the security switch
is turned off, PCCU32 will have full access to the meter (even to change the security codes).
Meter security
To establish meter security:
Have the security switch in the OFF position.
Connect locally with PCCU32.
Enter a four digit number for level 1 and level 2 security codes (see Figure 54).
Table 12: XRC
Description Format
MM/DD/YY
DATE/TIME
HH:MM:SS
BATTERY NN.N VOLTS
CHARGER NN.N VOLTS
STATION ID XXXXXXXXXX
DEVICE ID XXXXXXXXXX

Figure 53: Meter setup and security screen

G4
displayed items
Note
24 hour clock
Battery Voltage Volts
Charger Voltage
10 Character alphanumeric identifier
10 Character alphanumeric
application or tube identifier
XSeriesG4 Remote Controller User's manual 2103334 Rev. AB | 57
3 XRCG4 startup
G4
) and the software (PCCU32