Xseries On-Board Input/Output; Table 6:Xrc Board Identification - ABB XSeriesG4 User Manual

ID number Description
1 Battery Connection
2 I/O Module Interface
3 LCD Display Interface
4 PCCU Interface
5 USB Extension Port
6 SD Card
7 Ethernet Connector
8 Reset Button (WARM Start)
9 Keypad Connector
10 Security Switch
11 Lithium Battery
12 Battery Cover
13 Battery Mounting Bracket
14 Memory Backup Enable/Disable

XSeries on-board input/output

G4
Totalflow's XRC features the base I/O listed below:
–
5 User A/I
–
User D/O
–
User D/I (2 may be used as High Speed P/Is (DI1 and DI2))
–
Up to 6 communication ports
–
Interface for TFIO modules
The main electronic board (XRC
Specifications for digital/pulse input, digital output and analog input follow in the next few pages. For a complete overview of the
G4
XRC board, see Figure 5.
Communication ports
Up to two on-board communication ports can be programmed on the main electronic board. Normally, COMM 0 is the local port
required for reading the XRC with a laptop computer running PCCU32. COMM 1 and COMM 2 can be configured for any
combination of RS-232 or RS-485. See Figure 5 for on-board Communication Ports. Six ports are available:
–
Dedicated PCCU/MMI (COMM 0)
–
2 RS-232 or RS-485 via plug-in modules (COMM 1 and 2)
–
TFIO I/O connection for use with the TFIO Communication Module
–
Ethernet
–
USB (host and client)
– Special USB cable required.
– Check with Totalflow for a list of drivers to support client peripherals.
Digital input
G4
The Totalflow XRC provides four digital inputs, or two digital and two high speed pulse inputs, as means to control external
G4
equipment with the XRC (See Figure 5: XRC board, items 19 and 20).

Table 6:XRC board identification

ID number
15
16
17
18
19
20
21
22
23
24
25
26
27
28
G4
board) is an enhanced replacement for previous versions of the RTU main electronic board.
Description
Analog Input Connectors
Analog Input Type Selection Jumper Pins
Auxiliary Power Output Connectors
DeBounce Enable/Disable
A Pulse Inputs/Digital Outputs Connectors
B Pulse Inputs/Digital Outputs Connectors
A Remote COMM1 Connectors
B Remote COMM2 Connectors
External Charger (Solar Panel) Connectors
Remote COMM1: Module Plug-in
Remote COMM1: RS-485 Termination Jumper
Remote COMM2: Module Plug-in
Remote COMM2: RS-485 Termination Jumper
CPU Engine Card
XSeriesG4 Remote Controller User's manual 2103334 Rev. AB | 9
1 System overview