Table of Contents
Advertisement
Default: 10 (Line Feed)
3.3.3.6 S5 - Command Line Editing Character
S5s sets the decimal value of the character recognized by the modem as a request to
delete from the command line the immediately preceding character. The modem will not
recognize the Command Line Editing character if it is set to a value that is greater than
32 ASCII. This character can be used to edit a command line. When the echo command
is enabled, the modem echoes back to the local DTE the Command Line Editing
character, an ASCII space character and a second Command Line Editing character;
this means a total of three characters are transmitted each time the modem processes
the
Command Line Editing character.
Range: 0-32, ASCII decimal
Default: 8 (Backspace)
3.3.3.7 S6 - Wait Time for Dial Tone Before Blind Dialing, or After "W" Dial Modifier
(W-Class Models)
S6 sets one of two possible parameters:
1. Sets the length of time, in seconds, that the modem will wait before starting to dial
after going off-hook when blind dialing. This operation, however, may be affected by
some ATX options according to country restrictions. The "Wait for Dial Tone" call
progress feature (W dial modifier in the dial string) will override the value in register S6.
2. For W-class models, S6 sets the length of time, in seconds, that the modem will wait
for dial tone when encountering a "W" dial modifier before returning NO DIAL TONE
result code.
The modem always pauses for a minimum of 2 seconds, even if the value of S6 is less
than 2 seconds.
Range: 2-255 seconds
Default: 2
3.3.3.8 S7 - Wait Time For Carrier After Dial, For Silence, or For Dial Tone After
"W" Dial Modifier (US Models)
S7 sets one of three possible parameters:
1. Sets the length of time, in seconds, that the modem will wait for carrier before hanging
up. The timer is started when the modem finishes dialing (originate), or 2 seconds after
going off-hook (answer). In originate mode, the timer is reset upon detection of answer
tone if allowed by country restrictions.
2. Sets the length of time, in seconds, that modem will wait for silence when
encountering the @ dial modifier before continuing with the next dial string parameter.
3. For US models, S7 sets the length of time, in seconds, that the modem will wait for
dial tone when encountering a "W" dial modifier before continuing with the next dial
string parameter.
Range: 1-255 seconds
Default: 50
3.3.3.9 S8 - Pause Time For Dial Delay
S8 sets the time, in seconds, that the modem must pause when the "," dial modifier is
encountered in the dial string.
Range: 0-255 seconds
Default: 2
3.3.3.10 S10 - Lost Carrier To Hang Up Delay
S10 sets the length of time, in tenths of a second, that the modem waits before hanging
Advertisement
Table of Contents
