Table of Contents
Advertisement
S3 Command Line Termination Character X X X X
S4 Response Formatting Character X X X X
S5 Command Line Editing Character X X X X
S6 Pause Before Blind Dialing X X X X
S7 Connection Completion Timeout X X X X
S8 Comma Dial Modifier Time X X X X
S10 Automatic Disconnect Delay X X X X
S11 DTMF Tone Duration X X X X
S12 Escape Prompt Delay (EPD) X X X X
S29 Flash Dial Modifier Time X X X X
Table 7-1. Command Set Summary - Functional Use Sort (Cont'd)
Configuration
Command Description Data/Fax Data/Fax/Voice Data/Fax/Voice/
Speakerphone
Data/Fax/Voice/
Speakerphone/
ISDN
Voice Commands
+VCID Caller ID (CID) - X X X
+VDID DID Feature - X X X
+VNH Automatic Hang-up Control - X X X
+VIP Voice Initialize All Parameters - X X X
+VRX Start Modem Receive (Record) - X X X
+VTS Voice Tone Send - X X X
+VTX Start Modem Transmit (Playback) - X X X
+VGR Voice Gain Receive (Record Gain) - X X X
+VGT Voice Gain Transmit (Playback Volume) - X X X
+VIT Voice Inactivity Timer (DTE/modem) - X X X
+VLS0-15 Analog Source/Destination Selection - X X X
+VRA Ringback Goes Away Timer - X X X
+VRN Ringback Never Appeared Timer - X X X
+VSD Silence Detection (QUIET & SILENCE) - X X X
+VSM Compression Method Selection - X X X
+VTD Beep Tone Duration Timer - X X X
+VDR Distinctive Ring - X X X
+VDT Control Tone Cadence Reporting - X X X
+VBT Buffer Threshold Setting - X X X
+VPR Select DTE/Modem Interface Rate - X X X
Speakerphone Commands
+VSP Speakerphone ON/OFF - - X X
+VDX Speakerphone Duplex Mode - - X X
+VLS16-19 Speakerphone Signal Control - - X X
+VGM Microphone Gain
+VGS Speaker Gain - - X X
Table 7-2. Command Set Summary - Alphanumeric Sort
Configuration
Command Description Data/Fax Data/Fax/Voice Data/Fax/Voice/
Speakerphone
Data/Fax/Voice/
Speakerphone/
ISDN
%E Enable/Disable Line Quality Monitor and Auto-Retrain X X X X
Advertisement
Table of Contents
