Verifying Your Connection - AOpen FM56 Manual

4.6 Verifying Your Connection

Start a communication program and place the computer into terminal mode. Refer to your
computer manual to find out the appropriate command to do so.
Then use the following procedure to verify your installation:
1. Type
If your system is operating properly, your fax/modem sends an OK response to your screen and
waits for your next command.
2. Use your communication software to prepare your
computer to dial a call. Then type
where x is equal to T for touch-tone or P for pulse
dialing. The phone number is your telephone number.
For example, if your fax/modem is connected to the telephone
line 555-2121 and touch-tone dialing is supported in your area,
type
ATDT 5552121[Enter].
3. You should hear the busy signal and receive a BUSY
response because the fax/modem is calling itself.
AT[Enter]
ATDx phone number[Enter]