Table of Contents
Advertisement
5. VOICE COMMANDS
5.1 Voice Commands Overview
Voice commands are identified in Table 5-1.
Table 5-1. Voice Commands
Command Function
Configuration
+FCLASS Set Mode
+VCID Caller ID (CID)
+VDID DID feature
+VNH Automatic Hang-up control
+FMI Manufacturer Identification
+FMM Product Identification
+FMR Version, Revision, etc.
+FLO Flow Control
Voice
+VIP Voice Initialize All Parameters
+VRX Start modem Receive (Record)
+VTS Voice Tone Send (Send single frequency or DTMF)
+VTX Start modem Transmit (Playback)
+VGR Voice Gain Receive (Record Gain)
+VGT Voice Gain Transmit (Playback Volume)
+VIT Voice Inactivity Timer (DTE/Modem)
+VLS Analog Source/Destination Selection
+VRA Ringback Goes Away Timer
+VRN Ringback Never Appeared Timer
+VSD Silence Detection (QUIET & SILENCE)
+VSM Compression Method Selection
+VTD Beep Tone Duration Timer
+VDR Distinctive Ring
+VDT Control Tone Cadence Reporting
+VBT Buffer Threshold Setting
+VPR Select DTE/modem Interface Rate (Turn off autobaud)
Speakerphone
+VSP Speakerphone ON/OFF
+VDX Speakerphone Duplex Mode
+VGM Microphone Gain
+VGS Speaker Gain
5.2 Voice Commands
5.2.1 Configuration Commands
5.2.1.1 +FCLASS=8 - Select Voice Mode
+FCLASS=8 selects the Voice Mode. The Voice Mode commands and responses
described in this section are applicable when command +FCLASS=8. (See Section
3.2.1.2 for the definition of the FCLASS command.)
5.2.1.2 +FCLASS=80 - Select VoiceView Mode
+FCLASS=80 selects the VoiceView Mode. The Voice Mode commands and responses
described in this section are applicable when command +FCLASS=80. (See Section
3.2.1.2 for the definition of the FCLASS command.)
5.2.1.3 +VCID - Caller ID (CID)
Advertisement
Table of Contents
