Table of Contents
Advertisement
Windows NT4.0:
1. Explorer the driver files on your CD.
D:\Drivers\WinNT\FM56-PL
2. If you are using the WINACPCI driver already stop it using the steps in the following list.
a)
Stop any programs (e.g., HyperTerm) that are using the modem driver
b)
Click on Start, then Settings, then Control Panel.
c)
Start the Devices applet
d)
Scroll down to WinAcPci and highlight it
e)
If the display says "running", continue with the next step. If not,
you are done.
f)
Press the STOP button and say "yes", you do want to stop the driver.
g)
Wait until the driver stops (there should be a "wait" dialog to watch)
h)
Where the applet said the driver was "running" should now be blank
3. Start SETUP.EXE with a double click or by highlighting the file and pressing the ENTER key.
You should see a welcome screen. Click on the NEXT button.
4. You should see "AOpen FM56-PM(SM) Data Fax Speakerphone PCI Modem" in the display
window. Highlight it by clicking on the text. Click on the NEXT button to install the driver.
5. You should see a few copy operations and hear a small flurry of disk activity, and you should
see the next screen which says "the following drivers were installed successfully."
6. The driver is now installed and running. Note that you do not have to re-boot your system to
use the driver. You may exit the installation procedure and start HyperTerm to use the driver
on COM3 right now.
7. To continue the installation procedure to create the registry entries for the modem, perform
the steps in the following list.
a)
Click the check box titled, "Setup modem for the installed devices", and press the
FINISH button. You are now in the domain of the standard
Windows NT modem installer. If you have previously installed the NT modem, you will
see a listbox showing the installed modems on your system.
b)
If you are using the HCF modem already, remove it by clicking on it in the listbox and
pressing the REMOVE button. When the modem is gone, press the ADD button to
continue installing this version of the HCF modem.
8. There are two ways to finish the installation. The first way is to ask the installer to detect the
HCF modem. The second way is to select the HCF modem from the list using the "have disk"
feature.
9. To ask the installer to detect the modem, clear the "Don't detect my modem..." check box and
press the NEXT button. Windows NT will query every com port and find every modem
attached to your system. When it gets to COM3, it will detect a "standard modem". Click the
CHANGE button and prepare to select the modem INF file.
10. To select the modem from a list, check the "Don't detect my modem..." check box and press
the NEXT button. After a moment, NT will show the list. Press the HAVE DISK button to
select the HCF modem INF file.
11. At the "Install From Disk" dialog, enter the directory path where you loaded the installation
Advertisement
Table of Contents
