Schwinn NAUTILUS A10 User Manual page 15

Fan (if equipped) will not turn on or will not turn off
Fan (if equipped) will not turn on, but Console operates
Unit rocks/does not sit level
Pedals loose/unit difficult to pedal
Seat post movement
Check data cable integrity
Check data cable connections/orientation
Reset Machine (if equipped with reset button)
If bike has batteries, check Battery Indicator on console
or check batteries.
Check for blockage of fan
Check leveler adjustment
Check surface under unit
Check pedal to crank connection
Check crank to axle connection
Check locking pin
Check adjustment knob
15 15 15
All wires in cable should be intact. If any are cut or
crimped, replace cable.
Insure cable is connected securely and oriented
properly. Small latch on connector should line up and
snap into place.
Unplug unit from electrical outlet for 3 minutes.
Reconnect to outlet. After Console powers up, press
"reset".
If the battery level shows low or no power, replace
the batteries.
Turn power off (remove batteries or unplug power
adapter). Remove material from fan. If necessary,
detach the Console to help with removal. Replace the
Console if unable to remove blockage.
Leveling feet may be turned to level bike.
Adjustment may not be able to compensate for
extremely uneven surfaces. Move bike to level area.
Pedal should be tightened securely to crank. Insure
connection is not cross-threaded.
Crank should be tightened securely to axle. Be sure
cranks are connected at 180 degrees from each other.
Insure adjustment pin is locked into one of the seat
post adjustment holes.
Insure knob is securely tightened.