Schwinn 430 Owner's Manual page 14

USINGTHE 430 COMPUTER
==Auto Shut-Off (Sleep Mode)
The console will automatically shut off in approximately 2 minutes without
use or input. There is no on/off switch. (Press any button to power up the
console and "ENTER PROGRAM" appears in the alphanumeric display.)
I Information Mode
The computer enables you to switch between English or Metric units
by pressing and holding the UP and DOWN buttons simultaneously
for 3 seconds. Use the UP or DOWN button to select "ENGLISH" or
"METRIC" and press ENTER to confirm. The computer will enter the
Information Mode. In the Information Mode, by following the displayed
menu and prompts, you will be able to:
Select ENGLISH measurement units which sets the computer for:
• Miles
Miles/hour
Pounds
Inches
Or select METRIC measurement units which sets the computer for:
Kilometers
Kilometers/hour
Kilograms
• Centimeters
See Total Distance
See Total Hours
Press ENTER and then the software version will display. Press ENTER
again to exit the Information Mode and the computer will bring you to the
"ENTER PROGRAM" mode.
m Gdp Heart Rate
This Schwinn ® elliptical trainer is equipped with grip heart rate sensors
located on the handlebars. You must contact these sensors with both
hands so the computer can detect your pulse. The computer uses infor-
mation detected by the grip heart rate sensors for many of the software
features. Make sure you are gripping the pods and look for the flashing
"heart" icon and pulse rate located on the lower right portion of the LCD
display (to the left of the CYCLIST icon) indicating that a pulse signal is being
received. If there is no display, please see the section titled "IMPORTANT
Things You Should Know Before Exercising" for more information.
14