Schwinn 430 Service Manual page 59

13. Using a #2 Phillips screwdriver, remove the 4 screws that
secure the Right Shroud. Remove the bottom screws first, and then
the top screws. Slowly remove the Right Shroud.
14. Installation is the reverse procedure. Put the Left Shroud in
position first to align the screws for the Right Shroud. Install the top
screws first.
NOTICE: This step may require two people. Be sure not to
crimp any cables.
Note: Self-tapping screws attach the Shrouds to the Frame.
No screws hold the Manual Main Shroud in position.
Reach through the left or right side opening to stabilize it
while installing the screws.
Installation does not require the use of the crank puller. Be sure the
tabs in the Top Shroud snap into the Main Assembly.
15. Dispose of the old parts.
16. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
S
59