Schwinn 430 Service Manual page 25

4. Using a small flathead screwdriver, pry the Caps from
the Lower Handlebar Arms.
5. Using a 13mm wrench and a pair of pliers, remove the
hardware from the Lower Handlebar Arms and the Arm Pivot
Rod. Remove the hardware, Upper and Lower Handlebar
Arms, and Arm Pivot Rod. Set them safely aside for reassem-
bly.
Note: The hardware on both ends of the Arm Pivot Rod
will need to be held to remove it.
6.
Bend the edges of the Top Shroud to disengage the inside tabs from
the Main Assembly, and slide the Mast Boot and Top Shroud up the Mast.
7. Remove the hardware (indicated) from the Mast. Gently pull the Mast
out and disconnect the cables. Set the hardware and Top Shroud safely
aside for reassembly. Discard the Mast.
NOTICE: Do not crimp the cables. Do not allow the Data Cable to
fall down into the Main Unit. This step may require two
people.
8. Installation is the reverse procedure.
NOTICE: Do not crimp the cables. Do not allow the Data Cable to
fall down into the Console Mast.
9. Inspect your machine to ensure that all hardware is tight and compo-
nents are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
X2
13mm
X2
6mm
25
6mm
1
X4