Shrouds - Schwinn 430 Service Manual

4. Using a 6mm hex wrench, loosen and remove the indicated hardware
from the Legs, and set it safely aside for reassembly. On each side of the
machine, remove the Leg and Pedal together from the Rail Assembly and
set them safely aside for reassembly.
NOTICE: This step may require two people.
5. Bend the edges of the Top Shroud to disengage the inside tabs from
the Main Assembly, and slide the Mast Boot and Top Shroud up the Mast.
6. Remove the hardware (indicated) from the Mast. Gently pull the
Mast out and disconnect the cables. Set the hardware, Mast and Top
Shroud safely aside.
NOTICE: Do not crimp the cables. This step may require two people.
7. Twist the Center Cap (A) counter-clockwise and remove it from the
Crank Arm.
X2
X2
6mm
A
57
6mm
X4