Wiring - Jensen MP6512i Installation And Operation Manual

MP6512i

WIRING

NOTE: The amplifier in this radio
is only designed for use with four
speakers. Never combine (bridge)
outputs for use with two
speakers. Never ground negative
speaker leads to chassis ground.
Failure to wire exactly as shown
may cause electrical damage to
the radio.
NOTE: Only connect speakers
with a nominal impedance of 4
ohms. Speakers with a load
impedance less than 4 ohms
could damage the unit.
All manuals and user guides at all-guides.com
DATA BUS
DATA BUS
3.5mm
Audio Only
iPod Video
jLink iPod Cable
(Sold Separately)
SAT L SAT R SAT
source that is always live. The radio will
White/Black
Stripe
iPod iPod Mini iPod Nano
Left Speaker
5
Ground
Connect to ground terminal
or clean, unpainted part of chassis.
Black
Memory/Battery
Connect to battery or 12 volt power
not work if this wire is not connected.
Yellow
FRONT SP
White Gray/Black Gray
Stripe
Right Speaker
(Front) (Front)
Pow
Con
If no
Acc
Con
or ra
REAR
Green/Bl
Stripe
L