Jensen MP6512i Installation And Operation Manual page 13

MP6512i
select "OFF", "LOW", "MID" or "HIGH". When activated, "LOUDNESS"
appears on the display panel.
Local/Distant Reception (LO/DX)
When the Local function is on, only radio stations with a strong signal are
played. To activate Local reception mode, press the LO/DX button (6).
NOTE: Distant mode is indicated by a triangle with circles above it.
Menu Operation
Press and hold the MENU button (22) for more than two seconds to access
the menu. Press the MENU button repeatedly to move through the following
menu options: 12/24 HOUR, VOL LAST/VOL ADJ, BEEP ON/OFF, AREA
SET, BRIGHT. The following procedures assume you have already
accessed the menu.
12/24 Hour Time Format
This option allows selection of a 12 hour or 24 hour clock format. "12
HOUR" is the default setting. Turn the rotary encoder to change to the 24
hour clock format.
Programmable Turn-on Volume Level
Press the MENU button (22) to select "VOL LAST" or "VOL ADJ".
• VOL LAST: When the unit is turned on, the volume will resume at the
level selected when last turned off.
• VOL ADJ: After selecting "VOL ADJ", press the MENU button and then
turn the rotary encoder (22) to select the desired level. When this option
is selected, the unit will revert to the adjusted volume each time the unit
is turned on.
Beep Tone
The beep tone feature allows the selection of an audible beep tone to be
heard each time a button is pressed on the face of the radio. "BEEP ON" is
the default setting.
To turn the audible beep off:
1. Press the MENU button (22) to select "BEEP ON".
2. Turn the rotary encoder to select the "BEEP OFF" option.
Frequency Spacing (AREA SET)
This option allows you to select the appropriate frequency spacing for your
area. "U.S.A." is the default setting. Turn the rotary encoder to select
"EUROPE", if needed.
All manuals and user guides at all-guides.com
Brightness Adjustment
This option allows you to adjust the brightne
rotary encoder to select a brightness level b
being the brightest.
Clock Set
1. Press and hold the DISP button until the
2. Turn the rotary encoder (22) to the right
to set the minutes.
Reset Button
The RESET button (4) is located on the fron
encoder. The reset circuitry protects the mic
resetting the unit will erase the time and pre
activated upon initial installation after all wir
malfunction of any of the switches on the un
pressing the RESET button will clear the sy
normal operation.
9