Jensen MP6512i Installation And Operation Manual page 7

MP6512i
CAUTION: For proper operation of the CD player, the chassis must be
mounted within 20° of horizontal. Make sure the unit is mounted within
this limitation.
4. Place the radio in front of the dashboard opening so the wiring can be
brought through the mounting sleeve. Follow the wiring diagram
carefully and make certain all connections are secure and insulated
with wire nuts or electrical tape. See "Wiring" on page 5. After
completing the wiring connections, turn the unit on to confirm operation
(vehicle ignition must be on). If the unit does not operate, re-check all
wiring until the problem is corrected.
5. Make sure the radio is right-side up, then
carefully slide the radio into the mounting
sleeve until it is fully seated and the spring clips
lock it into place.
6. Secure the rear of the unit to the car body
using the mounting bolt and rubber cushion.
7. Test the radio using the Operating Instructions
that follow.
BEND TABS
All manuals and user guides at all-guides.com
SPRING CLIP
RADIO
TRIM RING
Kit Installation
If your vehicle requires the use of an installa
follow the instructions included with the inst
the mounting plate supplied with the kit.
1. Wire and test the radio as outlined in th
instructions.
2. Install the radio/mounting plate assemb
according to the instructions in the insta
3. Attach the support strap to the radio and
Universal Installation instructions.
4. Replace the dashboard trim panel.
ISO Installation
This unit has threaded holes in the chassis
side panels which may be used with the
original factory mounting brackets of some
vehicles to mount the radio to the
dashboard. Please consult with your local
car stereo shop for assistance on this type
of installation.
1. Remove the existing factory radio
from the dashboard or center console
mounting. Save all hardware and
brackets as they will be used to mount t
MOUNTING
2. Carefully unsnap the plastic frame from
SLEEVE
chassis. Remove and discard the frame
RUBBER
3. Remove the factory mounting brackets
CUSHION
radio and attach them to the new radio.
MOUNTING BOLT
maximum screw size. Longer screws m
the chassis.
4. Wire the new radio to the vehicle as outl
instructions.
5. Mount the new radio assembly to the da
using the reverse procedure of step 1.
Fuses
When replacing a fuse, make sure the new
amperage. Using an incorrect fuse could da
Reconnect Battery
When wiring is complete, reconnect the bat
3