System board
Removing system board
1
Follow the procedure in
1
If your computer is shipped with a WWAN card, then the removal of a blank SIM card tray is a requirement.
2
Remove the:
a
SIM card
b
base cover
c
battery
d
memory module
e
PCIe SSD
f
WLAN card
g
WWAN card
h
heat sink assembly
2
3
To disconnect the eDP cable:
NOTE:
If your system is shipped with an IR camera, then the IR cable must be disconnected. The IR cable is located
beneath the eDP cable connector
a
Un route the WLAN and WWAN cables from the routing channels [1].
b Remove the M2.0 x 3.0 screws that secure the eDP cable [2].
c
Remove the eDP cable bracket [3].
d Disconnect the eDP cable from the system board [4].
e
Lift the tape that secures the eDP cable to the system board [5].
Before working inside your
computer.
Disassembly and reassembly
37