Sanyo XG-705A Owner's Manual page 77

2. Check Option items
Check the conditions where you would choose the projector to send an alert message.
Regarding the alert message, see samples below.
3. Enter the message to attach the E-mail.
The message typed here will be attached to the alert message.
Samples of Alert Message
* When the internal temperature is too high
TITLE: Message from projector
Projector Model Name: XX100
TCP/IP: 192.168.0.111 Projector Name:
It sends you following message.
✳
The Projector lamp is turned off, because internal projector temperature is too high.
Wait for the Temperature Warning Indicator to be turned off, and then turn the Projector on again.
If the Indicator continues flashing, check the air filter for dust accumulation.
"A" 21.5degrees centigrade"B" -13.7degrees centigrade"C" 51.6 degrees centigrade
Temperature of Sensor B is too high.
Temperature of Sensor C is too high.
✳
The Network projector let users know the information which thermal sensor "A," "B," or "C" inside
the projector detected the abnormal temperature risen and so the projector was turned off. Please
refer to the item "Check the status of projector" for the location of the sensors "A," "B," and "C,"
and temperature (p.79). Also see the owner's manual of the projector for further details.
* When the internal power is failed
TITLE: Message from projector
Projector Model Name: XX100
TCP/IP: 192.168.0.111 Projector Name:
It sends you the following message.
✳
The Projector lamp is turned off, because projector power circuit is failed.
Unplug this projector from AC outlet and ask for servicing to qualified service personnel.
✳
The Projector lamp was turned off, because the projector power is failed.
Unplug the projector from AC outlet and ask servicing to a qualified service personnel
* When the life of the lamp has been expired
TITLE: Message from projector
Projector Model Name: XX100
TCP/IP: 192.168.0.111 Projector Name:
It sends you the following message:
✳
The life span of lamp is reached. Lamp replacement is required.
✳
Replace it with a new lamp immediately and reset the lamp counter. If the projector is used without
resetting the lamp counter, the alert e-mail will be sent every time turning on the projector.
* When the time to clean filter comes
Warning mail will be sent when the time to clean filter comes. Time is set in the Filter counter.
10. How to Use the PJ Controller
77