Sanyo XG-705A Owner's Manual page 16

2. Setup Procedures
To use the projector via the networks, follow the setup procedures below.
STEP 1
STEP 2
STEP 3
16
Install the software on computers.
Install the software recorded in CD-ROM on each computer which will be
operated. Read following pages of this chapter to install.
Select Wired LAN or Wireless LAN then connect
the LAN and set the configuration.
Decide depending on the LAN environment.
Wired LAN .......Refer to "4. Wired LAN Configurations" (pp.25–31).
Wireless LAN ...Refer to "5. Wireless LAN Configurations" (pp.33–38).
Detailed LAN configurations need to be done with a browser later.
First, complete the Wired or Wireless LAN connection between computers and
projectors, then start browser configurations.
➔ "6. Configurations with Browser" (pp.39–54).
Network Configuration has completed.
Follow each chapter to project an image and operate the projector.
■ Project an image on the computer
➔ "7. Project the Image via the Networks" (pp.55–56).
■ Project an image with the moderator function
➔ "8. Use the Moderator Function" (pp.57–62).
■ Project an image on a network server
➔ "9. How to Use Network Viewer" (pp.63–71).
■ Operate and manage the projector
➔ "10.How to Use the PJ Controller" (pp.73–88).
Multi Control Function (pp.89–90).