Sanyo XG-705A Owner's Manual page 56

Network set-up and operation
Table of Contents

Advertisement

7. Project the Image via the Networks
Network Projector
List
1. Activate NetworkModule Client (Participants) or NetworkModule Moderator (Moderator).
2. Adjust the projector input to the selected network (Wired or Wireless) with the PJ
Controller. When operating multiple projectors, adjust each projector independently. Refer
to "10. How to Use the PJ Controller" (pp.73–90).
3. Select a projector from the Network Projector List with a mouse cursor. When selecting
multiple projectors at the same time, press the [Ctrl] key and select projectors with the
mouse cursor. Selected projector will be blue. You can operate up to 5 projectors at the
same time.
4. Click the Real time Capture button to project the computer image in real time.
✳ If the projector has already been being used, "In-use" message will appear on the
Network Projector List. When the "Accept Interruptive Connection" setting is "Enable",
you can use the projector even if it has "In-use" message. When the setting is "Disable",
you cannot use the projector. Refer to "6. Configurations with Browser" ➔ "Advanced
Setup" ➔ "Miscellaneous" (p.52).
On the Real time Capture screen, the destination projector will be displayed in blue or black.
When Real time capturing has been done, the Real time Capture button will become the Stop
Capture button.
Click the One-shot Capture button to project a copied still picture of the computer screen.
The quality or transmission speed of the projected picture can be set through Advanced
settings. Click the Advanced settings button to display the menu. Select "Quick" or "Clear"
with the check button.
When selecting "Quick", the image transmission speed will be quicker but the image quality
will be lower. When selecting "Clear", the image quality will be better but the transmission
speed will be slower.
When the User PIN code has been set, User PIN code screen will appear after clicking the
Capture buttons. If multiple projectors have different PIN codes, you need to enter PIN codes for
every projector. To set the User PIN code, refer to "4. Wired LAN setting" ➔ "Set the User PIN
code" (p.30), "6. Configurations with Browser" ➔ "Advanced Setup" ➔ "User PIN code" (p.50).
The same procedure will be required when operating via Moderator screen (NetworkModule
Moderator). While projecting the image in real time, the projector cannot be operated via PJ
Controller or browser.
✳ The projector cannot be connected to via the networks while using the viewer.
56
Real time Capture button
(While capturing the image, the
button will become Stop Capture
button.)
One-shot Capture button
PJ Controller button

Advertisement

Table of Contents
loading

Table of Contents