Table of Contents
Advertisement
WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
CAUTION:
Solid-state drives are fragile. Exercise care when handling the solid-state drive.
Topics:
•
Procedure
•
Post-requisites
Procedure
1
Align the notches on the solid-state drive with the tabs in the solid-state drive slot, slide the solid-state drive at an angle into the solid-
state drive slot, then press the other end of the solid-state drive down.
2
Align the screw holes on the hard disk plate with the screw holes on the system board.
3
Replace the two screws (M1.6x2.5) that secure the hard-disk plate to the system board.
4
Adhere the display-cable tape to the hard-disk plate.
Post-requisites
1
Replace the battery.
2
Replace the
base
cover.
16
Replacing the solid-state drive
Replacing the solid-state drive
computer. After working inside your computer, follow the instructions in
After working inside
www.dell.com/
8
Advertisement
Table of Contents
