Computer Input
Input Source Selection
Direct Operation
Press the INPUT button on the top control or the
COMPUTER button on the remote control to select either
Computer 1 or Computer 2.
Before using the INPUT or COMPUTER buttons, select the
correct input source through Menu operation as described
below.
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Use the Point
frame pointer to the Input Menu icon.
2
Use the Point
ed
pointer to either Computer 1 or Computer 2, and then
press the SELECT button.
3
After the Source Select Menu appeared for Computer
1, move the pointer to RGB and then press the
SELECT button.
✔Note:
• Computer 2 is not displayed when the COMPUTER IN 2/
MONITOR OUT terminal is set as Monitor out (p.49).
• Computer 2 (COMPUTER IN 2/MONITOR OUT) can
accept only the RGB signal.
• When the Input Search function is set On1 or On2, the
input signal will be searched automatically (p.49)
buttons to move the red
7 8
buttons to move the red arrow
Top Control
INPUT button
Remote Control
COMPUTER button
/
COMPUTER button
*See Notes at the bottom of this page.
Input Menu icon
Input Menu
CEILING
Move the pointer (red arrow)
to Computer 1 and press the
SELECT button.
Computer
1
Source Select Menu
Move the pointer to RGB
and press the SELECT
button.
Input Menu
Move the pointer (red arrow)
to Computer 2 and press the
SELECT button.
INPUT button
Computer 1
Computer *
Video
Computer 1
Computer *