Computer Input; (Rgb Scart 21-Pin Video Input); Selecting Input Source - Sanyo PLC-SE15 Owner's Manual

COMPUTER INPUT

Choose either Computer 1 or Computer 2 by pressing the INPUT
button on the Top Control or press the COMPUTER button on the
Remote Control.
If the projector cannot reproduce proper image, select correct input
source through MENU OPERATION (see below).
NOTE
G Computer 2 can be selected when the COMPUTER IN 2 /
MONITOR OUT terminal is set as Computer 2 at the menu item
"Terminal" in the SETTING Menu. (Refer to page 36.)
1 Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT button to move the red
frame pointer to the INPUT Menu icon.
2 Press the POINT DOWN button to move the red arrow pointer to
either Computer 1 or Computer 2 (Only the Computer 1 is
displayed when the Monitor out is selected in the SETTING
Menu.), and then press the SELECT button. The Source Select
Menu will appear.
3 Move the pointer to the correct input source and then press the
SELECT button.
When the input source is coming from a computer
RGB
through the COMPUTER IN 2 / MONITOR OUT
terminal, select RGB.
When the input source is coming from a DVD player
RGB (Scart)
through the COMPUTER IN 2 / MONITOR OUT
terminal, select RGB (Scart).
When digital signal is connected to DVI terminal,
RGB (Digital)
select Digital.
When analog signal is connected to DVI terminal,
RGB (Analog)
select Analog.
22

(RGB Scart 21-Pin Video Input)

SELECTING INPUT SOURCE

DIRECT OPERATION
MENU OPERATION
INPUT button
Computer 1
✽
Computer 2
Video
COMPUTER button
Computer 1
✽
Computer 2
✽
Computer 2 is not displayed when the COMPUTER
IN 2/MONITOR OUT terminal is used as Monitor out.
INPUT MENU
INPUT Menu icon
Move the pointer (red
arrow) to Computer 2 and
press the SELECT button.
Computer
Source Select Menu
Move the pointer to RGB
or RGB (Scart) and
press the SELECT but-
ton.
INPUT MENU
INPUT Menu icon
Move the pointer (red
arrow) to Computer 1 and
press the SELECT button.
Computer
Source Select Menu
Move the pointer to RGB
(Digital) or RGB
(Analog) and press the
SELECT button.
✽
Computer 2 is not displayed when the COMPUTER
IN 2/MONITOR OUT terminal is used as Monitor out.