Sanyo PLC-XL50 Owner's Manual page 49

Ceiling
When this function is set to "On, " the picture is top/bottom
and left/right reversed. This function is used to project the
image from a ceiling-mounted projector.
Rear
When this function is set to "On, " the picture is left/right
reversed. This function is used to project the image to a
rear projection screen.
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the back
of the projector is switchable for computer input or monitor
output (p.10). Select Computer 2 or Monitor Out with the
Point buttons.
7 8
Computer 2......computer input
Monitor Out......monitor out
Terminal function is not available when Computer 2 to the
input source is selected. Change the input source to the
others (Computer1 or Video) so that the Terminal function is
available (pp.27 , 37–38).
Input search
This function detects the input signal automatically. When
finding a signal, the search will stop. Use the Point
buttons to select one of the followings.
Off ...... Input search does not work.
On1 ...... Input search works under the situation below.
• When the COMPUTER button or VIDEO button
on the remote control is pressed.
On2 ...... Input search works under the situation below.
• When the projector is turned on with pressing
the ON/STAND-BY button on the remote control.
(After the countdown)
• When the COMPUTER button or VIDEO button
on the remote control is pressed.
•When the current input signal is missed.✳
✳ I f the No show or Freeze function is active, cancel it
to activate the Input search. It is not available when
On-Screen menu is displayed.
Ceiling
Rear
7 8
✔Note:
• While Input search is set On1 or On2, the
status of Input and Lamp are displayed
every time the signal is switched.
• Only the input source selected at the last
time can be detected.
• If the COMPUTER/VIDEO button on the
remote control is pressed while Input
search is on, Input search will stop and go
back to the previous input sign.
Setting