Lamp Replacement - Sanyo PLV-65WHD1 Owner's Manual

LAMP REPLACEMENT

The projection lamp has a service life and it needs to be
replaced when it reaches the end-of-life. When the lamp of
this LCD Projection TV reaches the end-of-life, the LAMP
REPLACE indicator will light yellow. If this indicator turns to
yellow, replace the lamp with a new one promptly.
CAUTION
Allow the LCD Projection TV to cool, for at least 30
minutes before you open the Lamp cover. The inside
of the LCD Projection TV can become very hot.
Follow these steps to replace the lamp assembly.
Turn off the LCD Projection TV and unplug the AC
1
power cord. Allow it to cool for at least 30 minutes.
2 Press the latches on both sides of the front cover
and pull the front cover forward.
Loosen the screw that secures the lamp cover with
3
a screwdriver and remove the lamp cover.
Loosen the two (2) screws that secures the lamp
4
assembly and pull out the lamp by holding the holes
on both sides.
Replace the lamp with a new one and secure it with
5
the two (2) screws. Make sure that the lamp is
seated properly into the lamp compartment. (Refer
to page 32 for ordering the replacement lamp.)
Put back the lamp cover and secure it with the
6
screw, and then put back the front cover.
Connect the AC power cord to the Power Cord
7
Connector and turn on the LCD Projection TV.
Reset the lamp counter. See "Lamp Counter Reset"
8
on page 28.
CAUTION
When installing the new lamp into the lamp
compartment, make sure the lamp socket is
securely plugged into the compartment socket.
Improper or loosen socket connection may cause
arc discharge resulting fire hazard.
This indicator will light
yellow when the projection
lamp reaches the end-of-life.
FRONT PANEL
LAMP LAMP
REPLACE REPLACE
CAUTION
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass bulb!
The glass can shatter and may cause injury.
Press and hold
this button and
pull the front
cover forward.
Loosen the screws.
Loosen two screws.
Hold here and pull out
the lamp.
(There are holes inside)
WARNING
Press the latch
on both side.
Lamp cover
31