Connecting Stb With Dvi Output To Hdmi Input; Connecting Digital Audio Out To A Multi-Channel Receiver - Sanyo PLV-65WHD1 Owner's Manual

CONNECTING STB WITH DVI OUTPUT
TO HDMI INPUT
Switch off the LCD Projection TV and external
equipment before connecting cable. (Cable is not
supplied.)
1 Connect the STB's DVI Output to a "DVI to HDMI
Cable;" then connect the cable to the LCD
Projection TV's HDMI input.
Note: Check with your local electronics store for a
DVI to HDMI Cable that matches your equipment and
the LCD Projection TV.
Connect the STB's Audio L / R to the LCD
2
Projection TV's VIDEO3 Audio L / R.
The LCD Projection TV must be turned on first,
3
press POWER. Then turn on your external
equipment.
Press INPUT to select HDMI to view a digital
4
program.
SET-TOP BOX (Can be a Digital Satellite Receiver,
DVD PLAYER, or similar digital device.)
1
DVI TO HDMI
CABLE
R-AUDIO-L
DIGITAL
HDMI AUDIO
OUTPUT
AUDIO
OUTPUT
REMOTE CONTROL
INPUT
POWER
1 2 3
What you will need for connections:
4 5 6
4
DVI to HDMI Cable – 1
3
Audio Cable – 1
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must run All
Channel Search twice before you can select the AV inputs.
■
Press the INPUT key after connecting cables to access the
AV Inputs. There is NO need to tune to a blank channel.
■
With a DVI connection, make sure you connect Audio out to
the LCD Projection TV's VIDEO3 Audio in.
14
Y–––––Pb–––––Pr R-AUDIO-L
VIDEO
(MONO)
3
Y–––––Pb–––––Pr R-AUDIO-L
VIDEO
2
S-VIDEO
R-AUDIO-L
VIDEO
PTV BACK
CONNECTING DIGITAL AUDIO OUT
TO A MULTI-CHANNEL RECEIVER
Dolby® Digital Audio provides 5.1 channels of surround
sound (five full-range channels [5] and one low-
frequency effect channel [.1]). A fiber optics cable is
used to carry the 5.1 surround sound (for low-noise
signal transfer).
Using a Fiber Optics cable, connect the LCD
1
Projection TV's Digital Audio Output to the Digital
Audio Input of a Multi-Channel Receiver. (Fiber
optics cable is not supplied.)
Press POWER to turn on the LCD Projection TV,
2
then turn on external equipment.
Notes:
When making the connection, do not pinch or kink
the fiber optics cable.
Red light visible at the Digital Audio Output does not
necessarily indicate that Dolby® Digital 5.1 audio is
available. Digital audio is made up of light pulses that
the human eye cannot detect. Dolby® Digital 5.1
audio is available at the Digital Audio Output only
when received as part of a Digital signal.
2
1
AUDIO
CABLE OPTICAL
DIGITAL CABLE
(MONO)
(MONO)
(MONO)
What you will need for connections:
OPTICAL Cable – 1
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must run All
Channel Search twice before you can select the AV inputs.
■
Because the VIDEO3 audio jacks are used to receive the
audio from the DVI device, these video jacks cannot be
used when a DVI device is connected.
■
"No Signal" will appear on the screen when no signal is
detected.
MULTI-CHANNEL
RECEIVER
PTV BACK
REMOTE CONTROL
INPUT
POWER
1 2 3
4 5 6
2