Lamp Replacement - Sanyo PLV-55WHD1 Service Manual

■ Lamp Replacement

When the life of the projection lamp of this LCD Projection TV
draws to an end, the LAMP REPLACE indicator will become
yellow. If this indicator turns to yellow, replace the lamp with a
new one promptly.
CAUTION
Allow a LCD Projection TV to cool, for at least 30
minutes before you open the Lamp cover. The inside of
the LCD Projection TV can become very hot.
Follow these steps to replace the lamp assembly.
1
Turn off the LCD Projection TV and disconnect the AC plug. Allow
the LCD Projection TV to cool for at least 30 minutes.
2 Press the latches on both side of the front cover and pull the front
cover forward to remove.
3 Loosen a screw that secure the Lamp Cover with a screwdriver
and remove the Lamp Cover.
4
Loosen 2 screws that secure the lamp with a screwdriver and
pull out the Lamp by holding the holes on both sides.
5
Replace the Lamp with a new one and put it back and tighten 2
screws. Make sure that the Lamp is correctly secured into the
Lamp compartment.
6
Put the Lamp Cover back and tighten the screw, and then replace
the front cover.
7 Connect the AC Power Cord to the Power Cord Connector and
turn on the LCD Projection TV.
8
Reset the Lamp replace counter.
See "Lamp Replace Counter" on the next page .
CAUTION
When installing the new Lamp into the Lamp compartment, make sure
the Lamp socket is securely plugged into the compartment socket.
Improper or loosen socket connection may cause arc discharge result-
ing fire hazard.
This indicator becomes yellow
when the life of the projection
lamp draws to an end.
CAUTION
For continued safety, replace with a lamp of the same
type. Do not drop a lamp or touch a glass bulb! The
glass can shatter and may cause injury.
With
the button, pull
the front cover
forward.
Loosen the screw
Loosen the screw
- 12 -
Front Panel
LAMP
REPLACE
pressing
Lamp Cover
Part (a)
Part (a)
Loosen the screw
Hold here and pull out the lamp.
(There are holes inside)
WARNING
Press the latch
on both side.
LAMP