Install Batteries; Connect Ac Power Cord - Sanyo PLV-65WHD1 Owner's Manual

INSTALL BATTERIES

2
• Install two "AAA" Batteries (not included) so that
the "+" and "–" marks on the batteries match the
"+" and "–" marks inside the remote control.
To review the remote control function, go to pages
18–19.
Note: Use two "AAA" alkaline batteries.

CONNECT AC POWER CORD

3
• Connect the AC Power Cord (supplied) to the LCD
Projection TV and electrical outlet.
This LCD projection TV uses nominal input voltages of
120 V AC. It is designed to work with single-phase
power systems having a grounded neutral conductor.
To reduce the risk of electrical shock, do not plug into
any other type of power system. If you are not sure of
the type of power being supplied, consult your
authorized dealer or Sanyo Fisher customer service.
Connect the LCD Projection TV with all peripheral
equipment before turning it on. (See pages 12–17 for
connection.)
CAUTION
For safety, unplug the AC power cord when the LCD
Projection TV is not in use.
While this LCD Projection TV is connected to an outlet
with the AC power cord, it is in Stand-by mode and
consumes a little electric power.
THE AC OUTLET MUST BE NEAR THIS EQUIPMENT
AND MUST BE EASILY ACCESSIBLE.
8
IMPORTANT: Spent or discharged
batteries must be recycled or disposed
properly in compliance with all applicable
laws. For detailed information, contact
your local County Solid Waste Authority.
REMOTE CONTROL
To POWER CORD
CONNECTOR on back of
LCD Projection TV.
AC Power Cord
To 120 V AC Outlet.