16
KTM POWERPACK, BATTERY CHARGER
16.8
Changing charging socket protection cap
Warning
Risk of injury There is a risk of electric shock when working on high-voltage components.
Work on high-voltage components requires special training, qualifications and tools.
–
Have all work that is not described and explained performed by trained KTM mechanics only.
–
Do not open the electric motor or the lithium-ion battery (KTM PowerPack).
Info
If the safety cord or seal ring is damaged or torn off, the charging socket protection cap must be replaced.
–
Switch off the battery charger using switch
After several seconds, all LEDs on the battery charger go out.
–
Disconnect the battery charger power plug from the power supply socket.
–
Disconnect the charging cable from the KTM PowerPack.
Guideline
Pull on the structured part of the connector. Do not pull on the cable.
–
Check the seal on the charging socket protection cap.
»
If the seal is dirty:
C00769-11
–
Clean the seal without using water or compressed air.
»
If the seal is damaged or worn:
–
Change the seal.
–
Mount the charging socket protection cap.
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
Main work
–
Remove
Guideline
Do not loosen
–
Remove residual safety cord.
–
Remove screws
–
Take off the carry handle.
M00743-10
–
Install new charging socket
Charging socket protection cap (000700000FX01)
–
Position loop around the right
M00744-10
p. 37)
p. 63)
p. 96)
p. 64)
charging socket protection cap.
nut.
.
protection cap.
carry handle attachment.
.
102