All Channel Search; Analog Antenna Signal (Optional) - Sanyo DP32746 Owner's Manual

3

ALL CHANNEL SEARCH

When the television is powered on for the first
time, it automatically checks for the presence of
an RF signal.
• Press the Power key
to turn on the DTV.
• Then press the Chan-
nel Up (CH L) key to
automatically search
for available channels:
Digital (ATSC)
Analog (NTSC).
The All Channel Search
contains two processes
that are executed simul-
taneously for digital and
analog channels.
NOTES:
The on-screen message for digital search will appear
with a progress bar and percentile number displayed
across the bottom of the screen (to indicate activity)
as the search process continues.
Channel information found during the All Channel
Search is stored in Analog and Digital Channel Scan
Memory databases. After the All Channel Search is
completed, the DTV will tune to the lowest Digital
channel or lowest Analog channel if no digital chan-
nels are found.
8
Need help?
Visit our Web site at
and
www.sanyoctv.com
If the DTV does not detect any digital or analog
channels, a message advising the viewer to check
the cables and antenna connections will appear. In
this case, you must press the CHANNEL UP (
L ) key again to repeat the channel search process.
If after two searches the DTV still fails to detect any
channels, the DTV will tune to analog channel 3.
These two channel searches are necessary even
if you plan to use the DTV only as a monitor.
If no analog or digital channels are found after
the second search, All Channel Search will default
to off-air analog channels 2 through 69 and digital
channel D3-1. Select analog channels using
the remote control keypad. See page 17 , item
number 2.
4
ANALOG ANTENNA SIGNAL
(OPTIONAL)
To change the initial analog tuning system setup
(from antenna to cable or cable to antenna), use
the on-screen menu, see "Analog Antenna
Signal" on page 22.
1-800-877-5032
or Call
CH