Drive cage
You must rotate the drive cage to the upright position to access components underneath it.
To rotate the drive cage:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Disconnect the power and data cables from the rear of the drives in the drive cage.
5.
Lift the rear of the drive cage up (1), and then slide the drive cage back (2). Then lift the drive cage (3)
out of the chassis.
32
Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
18)
(Front bezel on page
19).
17)