Table of Contents
Advertisement
8
ALARM REC MODE SET
This unit's motion sensors cannot be used when a
multiplexer is connected. In such a case, please use the
multiplexer's motion sensors.
When using the multiplexer's motion sensors, connect
the alarm output on the multiplexer to this unit's alarm
input.
When using a multiplexer, connect its ground terminal
and the recorder's ground terminal.
Setting the motion sensor
If a motion sensor is set on the monitor, alarm recording
will be carried out when a moving subject is detected.
1
Move the cursor to "MOTION SENSOR"
and press the [ ] button.
The motion sensor screen is displayed.
Motion sensor
screen
2
Press the [ ] or [ ] button to select
sensor operation positions (up to 80),
then press the [
confirm the selection.
Press the [
] or [
] button to turn sensors "ON" (shown
as ) and "OFF" (shown as
Setting
example
3
Move the cursor to "LEVEL", then press
the [
] or [
setting.
English
] or [
] button to
).
] button to change the
[Settings] (
indicates default setting.)
Setting
OFF
Not carried out
Motion sensing will be carried out. Lower values
1 to 10
correspond to higher sensitivities.
4
Move the cursor to "EXIT", then press
the [
] or [
<ALARM REC MODE SET> screen.
5
Press the [EXIT/OSD] button.
The display returns to the normal screen.
If recording is ended during alarm recording
using the motion sensor
Set the sensitivity from the motion sensor screen to
"OFF". (See the procedure 3.)
Pressing the [MENU RESET] button in the motion
sensor screen sets the entire row in which the cursor is
located.
67
Description
] button to return to the
Advertisement
Table of Contents
