Motion Sensor Level; Motion Sensor Set - Sanyo DSR-3000P Manual Manual

Manual for remote operation by network connection

Hide thumbs Also See for DSR-3000P:

Table of Contents

Menu Setting Procedures

MOTION SENSOR LEVEL

An alarm can be activated if the built-in motion

sensor on the screen detects an intruder, etc.

First set a detection level for the motion sensor

built-in on the monitor.

Select a motion sensor level from the pull-

down menu on the screen.

• OFF:

Sensor does not operate

• 1 to 10: Sensor level (the smaller the number the

higher the sensitivity)

If a multiplexer is being used, use the multiplexer

motion sensor.

Specify a setting range for the built-in motion

sensor on the screen.

Click a sensor position on the screen.

On the [MOTION SENSOR SET] screen, which has been

divided into a matrix 8 (H) × 10 (W), click the position

where you wish to establish a motion sensor and a sensor

setting mark will appear at that position. (If you click a

sensor position again, the sensor will be canceled.)

Any movement detected within the set range of a sensor

will automatically activate an alarm.

Click [SAVE] to complete the submenu settings (or changes).

English

(default setting: OFF)

Table of Contents