Table of Contents
Advertisement
2
MENU-SPECIFIC SETTINGS
(when optional interface board is installed)
Setting motion sensors
You can specify the position of motion sensors on screen
as described below. Alarm images are recorded when a
moving subject is detected at the specified position.
11
13
11
Set the motion sensor level.
[Settings] (
indicates default setting.)
Setting
OFF
Motion sensing is not carried out.
Motion sensing will be carried out. Lower values
1 to 10
correspond to higher sensitivities.
12
Click the location where the motion
sensor is to be setup.
"ON" (displayed ) is displayed for the corresponding
sensor.
Click again to turn the sensor "OFF" (i.e., no display).
13
Click [SAVE].
The new settings are saved.
12 Setting example
Description
108
10. DISPLAY SET
Set conditions for the display of data on the unit's monitor
by selecting "ON" or "OFF" for each item.
1
2
These settings apply to information displayed on the
monitor connected to the unit, not to the PC monitor's
display information.
1
Select "ON" or "OFF" for each data
display item.
Default
Item
setting
Sets whether the current date or recording
DATE
ON
date will be displayed.
Sets whether the current time or recording
TIME
ON
time will be displayed.
Sets the picture quality for recording or
QUALITY
ON
playback.
REC
Sets the recording rate for recording or
ON
RATE
playback.
Sets a maximum display quantity of 9,999,
ALARM
ON
and when this is exceeded, counting
COUNT
restarts from 0.
Sets the alarm recording type.
"ALARM" is displayed for alarm
ALARM
ON
recording.
TYPE
"PRE" is displayed for pre-alarm
recording.
2
Click [SAVE].
The on-screen data display conditions are set or modified.
Description
English
Advertisement
Table of Contents
