Bosch Climate 8000 RAC Owner's Manual page 9

Setting Angle of Air Flow
•
Setting vertical angle of air flow
While the unit is on, use the SWING /DIRECT button to set the
direction (vertical angle) of airflow.
1. Press the SWING /DIRECT button once to activate the
louver. Each time you press the button, it will adjust the
louver by 6°. Press the button until the direction you prefer
is reached.
2. To make the louver swing up and down continuously, press
and hold the SWING/ DIRECT button for 3 seconds. Press
it again to stop the automatic function.
Setting horizontal angle of air flow
The horizontal angle of the airflow must be set manually. Grip the
deflector rod (See Fig.2.3) and manually adjust it to your
preferred direction. For some units, the horizontal angle of the
airflow can be set by remote control. please refer to the Remote
Control Manual.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set louver at too vertical
an angle for long periods of time. This can cause water to
condense on the louver blade, which will drop on your floor or
furnishings. (See Fig. 2.2 )
When using COOL or HEAT mode, setting the louver at too
vertical an angle can reduce the performance of the unit due to
restricted air flow.
Do not move louver by hand. This will cause the louver to
become out of sync. If this occurs, turn off the unit and unplug it
for a few seconds, then restart the unit. This will reset the
louver.
Owner's Manual
CAUTION
Do not put your fingers in or near the blower and suction side
of the unit. The high-speed fan inside the unit may cause
injury.
Unit Specifications and Features | 9
6 720 869 160 (2016/12)