Countdown Timer; Rear Burner Operation; Wi-Fi Operation - Stanley Argon F500 OVAL Installation And Operating Instructions Manual

Table of Contents

Advertisement

Countdown Timer

The Countdown Timer allows for the Stove to be
operated for a set period (up to maximum of 9 hours
& 50 minutes) provided the Stove is set to Manual,
Thermostatic or Eco Modes.To set the Countdown
Timer:
1.
Press & hold the Countdown Timer Button
until the Countdown Timer Symbol is
displayed and the hour setting flashes- see
Fig 37.
2.
Press the Up Arrow Button & Down Arrow
Button to select the desired hour operating
period.
3.
Press the Countdown Timer Button to
confirm the setting.
4.
The minute setting will flash and press the
Up Arrow Button & Down Arrow Button to
select the desired minute operating period.
5.
Press the Countdown Timer Button to
confirm the setting. The Countdown Timer
Symbol & Timer Clock will be shown on the
remote display with the remaining time on
the period shown.
To deactivate the Countdown Timer, press & hold
the Countdown Timer Button until the Countdown
Timer Symbol & Countdown Timer Clock disap-
pears.

Rear Burner Operation

The Rear Burner can be turned On or Off as desired
by pressing the Rear Burner Button until the Rear
Button Symbol is displayed and the rear burner is
ignited (see Fig 38). To deactivate, press the Rear
Burner Button until the Rear Button Symbol disap-
pears.

WI-FI OPERATION

The Argon Stove can be operated remotely using
the myfire app by connecting the optional myfire Wi-
Fi Box (Part Code: B6R-W) and connecting same to
a Home Network (Wi-Fi Router). The myfire Wi-Fi
Box will operate for a short period of time using bat-
teries but if mains power is lost for a period of time,
it is recommended to disconnect the Wi-Fi Box from
the Gas Valve Control Box.
To set-up the myfire Wi-Fi Box, use the following
procedure:
1.
Connect the data cable to the Gas Valve
Control Box & myfire Wi-Fi Box (refer to
Wiring Diagram).
2.
Connect the Mains Adaptor to the Gas
Control Valve. After 30 seconds the myfire
Wi-Fi Box goes into Access Point Mode)
green LED flashes - see Fig 39.
Fig.37
Fig.38
Fig.39
20

Advertisement

Table of Contents
loading

Table of Contents