1886
Empty Post
Partially install three fixture screws, found
in the
shown, leaving the circled post empty.
10
Ceiling Bracket
Housing
Installing the Light Fixture
Fixture Screw
bag
Fixture
Screw
hardware bag, into the posts as
Keyhole
Slot
This is the screw you saved that
was attached to the red flag.
bag
Install the fourth fixture
screw and tighten all four
screws securely.
Downrod
Hanging Fan
3 of 4
4 of 4
Fixture Screw
Make sure the lower switch housing is securely
attached to the upper switch housing. Failure to
properly secure all three assembly screws could
result in the light fixture falling.
Wiring
Canopy
Blades
Connect the plugs from the upper and
lower switch housings. Make sure to
line up the colored markings on the
connectors and that the connectors latch.
Align the three keyhole slots in the light
kit with the three assembly screws in
the posts. Lift the light kit and twist
clockwise to lock it into place. Be sure
that both pull chains are hanging freely.
Install a bulb into each of the
sockets. When necessary, replace
with bulbs of the same wattage.
IMPORTANT
Hood
Light Fixture
Pull Chains
Glass/Cage