Installing The Light Fixture - Hunter Coral Gables II Installation Manual

1886
Empty Post
Partially install light kit assembly screws,
found in the
as shown, leaving the circled post empty.
WARNING
FAN FALL HAZARD
Make sure to secure the light fixture.
9
Ceiling Bracket Downrod

Installing the Light Fixture

3 of 3
Light Kit
bag
Assembly Screw
Light Kit Assembly
Screw
hardware bag, into the posts
Keyhole
Slot
This is the screw you saved that
was attached to the red flag.
1 of 1
Light Kit Screw
Install the saved light kit
screw and tighten all four
screws securely.
Hanging Fan Wiring
Connect the plugs from the upper
and lower switch housings. Make
sure to line up the colored markings
on the connectors and that the
connectors latch.
Align the three keyhole slots in the light
kit hood with the three assembly screws
in the posts. Lift the light kit assembly
and twist counterclockwise to lock it
into place.
Make sure the light kit assembly is securely
attached to the light kit hood. Failure to properly
secure all four screws could result in the light kit
falling.
Canopy Blades
Install a bulb into the
socket. When necessary,
replace with bulbs of
the same wattage.
IMPORTANT
Light Bulbs/Cage Remote Cradle