Installing The Light Fixture - Hunter Coral Bay Installation Manual

Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Partially install two of
the switch housing
assembly screws found
in the bag. It does
not matter which two
screw holes you choose.
Note:
Fan style may vary.
Carefully lower the glass
into the light fixture cage
until it rests in place.
Ceiling Bracket Downrod

Installing the Light Fixture

2 of 6
Light Kit Screw
bag
2 of 6
Light Kit Screw
bag
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Installing the Bulbs and Cage
Install the included LED
bulbs into the sockets.
When necessary, replace
with bulbs of same wattage.
Note:
Fan style may vary.
Hanging Fan Wiring
Feed the wire plug through the
center hole of the upper switch
housing, then wrap keyhole
slots around the screws and
twist counterclockwise.
Connect the plugs from the
upper and lower switch
housings. Make sure to line
up the colored markings on
the connectors
Tab
Notch
Lift the cage and align the
notches in the globe with
the tabs in the light kit.
Canopy Blades
bag
Insert the third screw,
found in the hardware
bag, into place and then
tighten all three screws.
bag
Align the keyhole slots in the light kit
housing with the two screws. Turn the
light kit counterclockwise until the light kit
screws are firmly situated in the narrow
end of the keyhole slots. Install the third
screw and tighten all three screws securely.
Attach the cage by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light Bulbs/Cage Remote Cradle
1886
1 of 6
Light Kit Screw
1 of 6
Light Kit Screw
ON
8