Fujitsu ScanPartner SP30 Operator's Manual page 33

Chapter 1 Scanner Overview
1.9 Basic Flow of Scanning Operation
This section explains about the basic flow of performing a
scan.
In order to perform a scan, you need a scanner driver and an
image scanning application that supports the scanner driver.
This product includes the following scanner drivers, and an
image scanning application.
Scanner drivers
- PaperStream IP (TWAIN) for ScanPartner
- PaperStream IP (TWAIN x64) for ScanPartner
- PaperStream IP (ISIS) for ScanPartner
Image scanning application
- Presto! PageManager
- ABBYY FineReader Sprint
HINT
For details about the scanner drivers and image scanning application,
refer to "1.10 Bundled Software" (page
Scanning procedures and operations will vary slightly
according to the image scanning application.
For details, refer to the manual of the image scanning
application.
The following describes the normal procedure for scanning.
35).
1
Turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page
2
Load a document in the ADF paper chute (feeder).
Load a document face-down in the ADF paper chute (feeder).
For details, refer to "Chapter 2 How to Load Documents" (page
3
Start the image scanning application.
4
Select a scanner driver.
For some image scanning applications, it may not be necessary to
select a scanner driver.
5
In the scanner driver's setup dialog box, configure the
scan settings.
For some image scanning applications, the scanner driver's setup
dialog box may not appear.
TOP
Contents
Index
Introduction
Scanner
24).
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
38).
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
33